After few weeks keep researching on how to etch a PCB, this week is my first time designing a PCB using Proteus software. Designing a PCB quite difficult, because i have to draw back all the circuit at the Proteus software then convert it to ARES. When it comes to ARES format, i have to arrange all the component and avoid wire jumper as possible. Below are my Proteus (ISIS) and ARES that already converted to the PCB layout.
Notice the circle mark, it is supposed to be LT1932, but its not available at Proteus. So, to solve this problem is, i just have to make footprint at the ARES which you can see at figure below.
Before etching the PCB, make sure all the component is fit at each soldering point or solder resist. On the left side is the upper and the right is bottom of the PCB. That's all for this week, see you guys next week.
No comments:
Post a Comment